Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateStyles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
See the difference
Before
After
Before
After
Before
AfterHow Much Does Spring Replacement Cost in Federal Way?
Spring replacement in Federal Way typically costs $180 – $340 for one spring, including the new spring and the labor to install it. Most homes here have a two-spring setup, and because both springs usually wear at the same rate, most jobs replace the pair together, which runs about $360 – $680. The written estimate sets the final price, and we offer free estimates so you know the number before any work starts.
Torsion and extension springs are what make a heavy garage door feel light enough to lift. When one snaps, the door either won’t open or drops hard, and the door is usually stuck until it’s fixed. Our technicians have up to 14 years of experience, and spring repair is a named service for us rather than a side job a generalist squeezes in, because it’s the most mechanically dangerous component on the whole door.
Key Takeaways
- One spring: $180 – $340. A matched pair: roughly $360 – $680.
- Most Federal Way doors carry two springs, and they’re typically replaced together.
- Upfront pricing and free estimates, so you get the number first.
- Trained technicians only for spring work; this is not a do-it-yourself job.
- Call (866) 937-7597 for a free estimate, including urgent calls when the door won’t open or close.
Spring Replacement Cost Breakdown (2026)
Here’s how the cost breaks down for Federal Way jobs. These are typical estimated ranges, and the written estimate you get is the final word.
| Item | Typical Estimated Cost |
|---|---|
| One torsion or extension spring, supplied and installed | $180 – $340 |
| Matched pair of springs (most common residential job) | $360 – $680 |
| Spring plus cable repair, if cables are frayed or off the drum | $130 – $250 added for the cable work |
| Bearing plate and center bracket replacement during a spring job | Quoted within the spring labor |
| Roller replacement alongside a spring job | $110 – $220 |
| Track realignment needed after a spring failure | $120 – $240 |
| Full garage door repair when the spring failure damaged other parts | $150 – $600 |
What pushes a spring job toward the higher end? Heavier doors, high-cycle springs, tight clearance in low-headroom garages, and rusted or seized hardware all add time. Doors that sat broken for a while often need track realignment or roller replacement too, because the door hung wrong on the torsion bar. What pulls the price down is straightforward: a standard single spring on a standard door with clean hardware is a quick, well-understood job. If you’re weighing a repair against a larger fix, read our guide to spring replacement for the full rundown on how the work is done. If the problem stretches beyond the spring into the opener or door panels, our Federal Way Garage Door Repair Pros page covers everything we handle.
What Affects Spring Replacement Pricing in Federal Way
Two houses on the same block can get different numbers because the door, not the address, decides most of the cost. Here’s what actually moves the estimate.
- Number of springs. Older single-spring doors need one; most modern two-car doors run a matched pair. A pair costs about twice a single spring because it’s two springs and two installs.
- Spring type and cycle rating. Standard torsion springs cost less than high-cycle springs rated for more open-close cycles. Homes where the garage is the main entry door wear springs faster, which is common in Federal Way where many people come and go through the garage daily.
- Door weight and size. A wide double door with insulated panels needs heavier springs, and heavier springs cost more than those on a light single door.
- Condition of the surrounding hardware. Rusty cables, worn rollers, or a bent track often get replaced at the same time. Catching these on the same visit saves a second call-out.
- Garage layout and clearance. Low-headroom garages or tight side clearance can change how long the job takes, especially when the torsion bar has to be reworked or a bracket is seized.
- Urgency. A door stuck open overnight is a security problem, and a same-day emergency visit can be priced differently than a scheduled job. We treat emergency service as a core offering, not an upsell, so call and we’ll tell you what’s realistic.
One local factor worth mentioning: Federal Way’s wet winters and damp springs mean rust takes a toll on older springs, cables and brackets. Rust weakens a spring and shortens its life, so a spring that looks fine but has surface corrosion is worth checking before it fails at an inconvenient moment. The climate here isn’t extreme on temperature, but the moisture is the thing that quietly ages metal hardware in a garage.
How to Save on Spring Replacement
You can’t make a broken spring cheaper by waiting, but you can keep the total down with a few sensible moves.
- Get a written estimate before work starts. Free estimates mean you can compare like for like. Call (866) 937-7597 to book one.
- Replace the pair together. If one spring of a matched set snaps, the other is usually near the end of its life. Replacing both in one visit costs less than two separate call-outs and avoids a second failure weeks later.
- Bundle related wear items. If your rollers are worn or a cable is frayed, replacing them during the spring job saves labor compared to booking it separately. Roller replacement on its own runs $110 – $220; folded into a spring visit it’s often less.
- Don’t put off a noisy or sluggish door. A spring that’s starting to fail often gives warning: the door feels heavy, lifts unevenly, or makes a loud bang when it lets go. Catching it before it snaps can avoid damage to the door and tracks.
- Ask about the right spring for how you use the door. If your garage is the everyday entry, a higher-cycle spring may cost a bit more now but last longer under daily use, which is cheaper over time.
We don’t pad the job. If a repair makes more sense than a full replacement, we’ll say so; if it’s the other way around, we’ll tell you that too. Repair or replace, we’ll tell you which one makes sense for your situation.
Safety: Why Spring Work Isn’t a Do-It-Yourself Job
Torsion springs are under extreme tension, and the tools and technique needed to release that tension safely are not something a homeowner should attempt. A spring that lets go while someone is working on it can cause serious injury. Extension springs carry the same risk. Our technicians handle this work as a specialist job, using the right winding bars and the correct procedure to bring the tension down safely before anything is removed. Please leave spring work to a trained professional; there’s no safe shortcut here.
Which Springs Do We Work On?
We work on your brand. We service garage doors and openers from eight of the most widely installed names in residential homes: LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor. Spring replacement itself is largely about the door’s weight and torsion system, but knowing the door and opener brand means our diagnosis is faster and more accurate than a generalist’s. If your opener is part of the problem, opener repair is its own service line for us (typically $120 – $320), because the drive, the safety sensors, and the logic board all need someone who knows them. If you need a whole new opener, installation runs $250 – $550. And if the door itself is at the end of its life, new door installation ranges $700 – $2200, so the same company that fixes today’s spring can spec and install a new door tomorrow.
Spring Replacement vs. Full Door Repair in Federal Way
Sometimes the spring is the only problem; sometimes it’s the first symptom of a door that needs wider work. A spring-only job lands in the $180 – $340 range for one spring. Broader garage door repair, where the spring failure bent a track or damaged a panel, falls in the $150 – $600 range. If your panels are cracked or dented, panel replacement runs $250 – $500 each on top of the spring work. The way to know which category you’re in is a diagnosis, which is why we start there rather than quoting blind.
If cables are involved, cable repair adds $130 – $250. Cables and springs fail together often, because a failing spring overloads the cable. We check both on every spring call so you’re not paying for a second visit a week later.
FAQs – Spring Replacement Cost
How much does garage door spring replacement cost in Federal Way?
One spring typically runs $180 – $340 installed, and a matched pair usually lands around $360 – $680 because the pair is replaced together. Your written estimate sets the exact price. Call (866) 937-7597 for a free quote.
Is it cheaper to repair or replace a garage door spring?
Repair is almost always cheaper than replacing the whole door, which runs $700 – $2200 for a new install. A spring swap at $180 – $340 per spring fixes the immediate problem. If the door is rusted through, cracking, or the tracks are bent beyond repair, we’ll tell you when a new door makes more financial sense.
Can you replace a broken spring the same day?
Yes, in most cases. Spring replacement is a same-day job when we have the right spring for your door on hand, and we carry common sizes. If your door is stuck open and the house is unsecured, call (866) 937-7597 and we’ll treat it as an urgent call.
Why do both springs usually get replaced at once?
Because a matched pair wears at the same rate, so when one breaks the other is usually close behind. Replacing both in one visit costs about the price of two single springs ($360 – $680 total) but spares you a second call-out, a second labor charge, and a second failure at the worst possible time.
Does a garage door spring replacement need a permit in Federal Way?
Spring replacement is generally a repair, not a structural change, so it usually doesn’t require a permit, but rules can vary. Check with the City of Federal Way’s building department if you want to be certain before work begins. For the estimate itself, call (866) 937-7597.
Why Homeowners Across Federal Way Call Us
Federal Way homes rely on the garage door as the everyday entry and the main security barrier. When a spring fails, both of those go at once. We treat spring work as a dedicated service, handle it with the care the job demands, and bring brand-specific knowledge of the eight major door and opener brands so we’re diagnosing by behavior, not guessing. Whether it’s a spring today or a new door down the road, we handle the full arc: diagnosis, repair, opener-specific repair, spring replacement, and installation.
Our technicians have up to 14 years of experience, estimates are free, and we give you the price upfront before any work starts. Emergency service is available when a broken door leaves your home open or traps your car.
Call (866) 937-7597 for a free estimate. Tell us what the door is doing, and we’ll tell you what it needs and what it costs.
Related Reading
If you’re sorting out a door problem beyond the spring, our Federal Way Garage Door Repair Pros home page lays out every service, and our dedicated spring replacement page explains how a torsion job works from start to finish. For pricing on opener trouble, cable wear, or a full new door, the same team can help. And if a snapped spring is the immediate problem, don’t wait: a door under tension with a broken spring is a safety issue, so call and let a trained technician handle it.
Written by the team at Federal Way Garage Door Repair Pros.
Pricing reflects the Federal Way market as of 2026. Federal Way Garage Door Repair Pros offers free estimates – call (866) 937-7597.
What Our Customers Say
"Replaced the bottom panel after I backed into it. Color match is close enough that you have to know to look for it."
- Eric Bennett"Both cables had come off the drum and the door was hanging crooked. I'd watched a video and was about ten minutes from trying it myself, which the tech told me would have been a genuinely bad idea. Glad I called."
- Sarah Parker"Door installed in about four hours, old one hauled away, and he stayed to program both cars and the wall panel before he left."
- Bryce Quinn