Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateStyles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
See the difference
Before
After
Before
After
Before
AfterHow Much Does Garage Door Cost in Kent?
Garage door repair in Kent typically runs $150 – $600, depending on what failed and how many parts are involved. The most common call we take, a broken spring, lands at $180 – $340 for one spring, and a new door installation runs $700 – $2200. A written estimate confirms the exact figure before any work starts, and estimates are free.
Those numbers cover a real spread, so the sections below break the range down by job type. If you’d rather skip the reading and get a number for your door, call (866) 937-7597 and we’ll talk it through.
- Typical repair: $150 – $600
- Spring replacement (one spring): $180 – $340
- Opener repair: $120 – $320
- New door installation: $700 – $2200
Garage Door Cost Breakdown (2026)
Here’s what each job type typically costs in Kent this year. These are estimated ranges for the work itself, not promotional starting prices.
| Service | Typical Estimated Cost |
|---|---|
| Garage Door Repair (general) | $150 – $600 |
| Spring Repair (one spring) | $180 – $340 |
| Cable Repair | $130 – $250 |
| Opener Repair | $120 – $320 |
| Opener Installation | $250 – $550 |
| Panel Replacement | $250 – $500 |
| Track Realignment | $120 – $240 |
| Roller Replacement | $110 – $220 |
| New Door Installation | $700 – $2200 |
One thing worth explaining up front: springs are almost always replaced as a matched pair. The two springs on your door share the load, and they wear at the same rate. When one breaks, the other is usually close behind it. So the spring price above is for one spring, and a pair costs about twice that range. We’ll tell you plainly whether your door takes one spring or two.
What pushes a job toward the top of its range? A few things. Broken cables often come with bent track, so you’re paying for two repairs instead of one. Panel damage on a discontinued door model can mean tracking down a matching panel, which is sometimes harder than it sounds. And if a door has been running rough for a while, you may find several worn parts at once: rollers, hinges, and a frayed cable that all reached the end of their life around the same time. On the lower end, a single bad roller or a misaligned sensor keeps a repair near the bottom of the range.
What Affects Garage Door Pricing in Kent
Kent’s housing stock and weather both shape what a door job costs here. Because Federal Way Garage Door Repair Pros connects homeowners with independent local professionals, every quote reflects the actual work on your door, not a flat rate card. Here’s what moves the number:
- Door size and weight. A standard single-car door is lighter work than a wide double door. Heavier doors need heavier springs and sturdier openers, and both cost more. A lot of Kent homes with attached garages have double doors that take a matched pair of springs, so budget for the pair rather than one.
- Brand and part availability. We work on eight of the most widely installed brands in residential homes: LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor. Because technicians diagnose by brand-specific behavior, the repair gets scoped correctly the first time rather than through trial and error. That saves you money more often than a cheap first visit that doesn’t fix the problem.
- What actually failed. A dead opener logic board, a snapped cable, and a worn roller are three very different jobs at three very different prices. The $150 – $600 repair range exists because those failures aren’t the same.
- Whether you repair or replace. A door that’s had panel damage, track damage, and a failing opener in the same year is often cheaper to replace than to keep patching. We’ll tell you which one actually makes sense for your situation.
- Weather exposure. Kent sits in the Puget Sound lowlands, where wet winters and damp air are the norm. That moisture works on steel panels, hinges, and rollers over time. Doors that face the prevailing weather tend to show rust and stiff hardware sooner, and stiff hardware wears out faster, which raises repair frequency.
- Access and door condition. A door that’s been sticking or off-track for months is usually a bigger job by the time someone calls. Tracks that get knocked out of alignment can bend cables and wear rollers, so a small problem left alone turns into a multi-part repair.
Repair or Replace? How to Think About the Cost
This is the question we get most, and there’s a simple way to reason about it. A repair in the $150 – $600 range is almost always the right call when the door structure itself is sound. The door is fine; a part failed. Replace the part.
Replacement starts to make sense when the door has structural problems that keep costing you money. Bent or rusted-through panels, a warped frame, tracks that won’t stay aligned after realignment, or a door so old that replacement panels no longer match. Add up what you’d spend repairing it, and if that number starts approaching a chunk of a $700 – $2200 installation, a new door is the better value. It also resets the clock on springs, cables, and rollers, which is where most repair money goes on an older door.
We’re happy to give you both numbers and let you decide. That’s part of what a free estimate is for. If you want a straight answer on your particular door, Federal Way Garage Door Repair Pros can walk you through it.
Spring Repair Costs in Kent
Spring repair in Kent typically costs $180 – $340 for one spring, and a matched pair costs about twice that because both springs are usually replaced together. Springs are the most dangerous component in your garage door system. They’re under high tension, and a spring that lets go while someone is working on it can cause serious injury. That’s why we treat spring repair as its own dedicated service rather than a general handyman job.
We won’t walk you through doing this yourself, and we’d encourage you not to try. The safe path is a trained technician with the right winding bars and the knowledge of how much tension your specific door’s spring carries. Our technicians have up to 14 years of experience, and spring work is a core part of what they do. If your door made a loud bang and won’t lift, that’s a spring, and it’s worth a call before you touch anything.
Opener Repair and Installation Costs in Kent
Opener repair in Kent typically costs $120 – $320, and a full opener installation runs $250 – $550. Opener problems aren’t all the same, which is why the range is wide. The remote might be fine while the logic board is failing. The drive system might be grinding while the safety sensors are misaligned. A general repair shop often changes the battery and calls it fixed. We service the drive, the sensors, and the logic board, not just the remote.
Brand matters here too. LiftMaster, Chamberlain, Genie, and Craftsman openers each have their own quirks, and knowing a brand’s typical failure points speeds up diagnosis. If your opener is old enough that parts are getting scarce, we’ll tell you whether repair or a fresh install is the better spend.
Cable, Track, and Roller Costs in Kent
These smaller repairs add up to more than people expect when several are needed at once, but individually they’re the most affordable work on the list. Cable repair runs $130 – $250, track realignment $120 – $240, and roller replacement $110 – $220. Cables are under the same high tension as springs, so we handle those with the same care and don’t recommend DIY work there either.
If your door is noisy, jerky, or drifting off its track, those are usually roller and track symptoms. Catching them early keeps the repair in the low range. Waiting lets the problem spread to cables and springs, which is where costs climb.
How to Save on Garage Door Costs in Kent
Most of the savings here come from timing and honesty about what your door needs. A few practical moves:
- Get the estimate in writing before the work starts. Free estimates mean you can compare real numbers. Call (866) 937-7597 and we’ll put a figure in front of you with no obligation.
- Fix small problems early. A sticking door or a noisy roller is a cheap repair. Left alone, it becomes a bent track and a stretched cable, which is a bigger bill.
- Replace springs as a pair. It costs more up front than one spring, but you avoid paying for the second one a few months later, plus a second service call.
- Ask whether repair or replacement is the better value. We’ll give you both numbers so you’re not talked into a new door you don’t need or patching one you should replace.
- Keep the door hardware lubricated. A little attention to hinges and rollers goes a long way toward preventing the wear that drives repair costs up.
Estimates are free, and there’s no pressure to book the work on the spot. The point is to know what you’re dealing with before you spend.
Does Emergency Garage Door Service Cost More in Kent?
Emergency garage door service is available, and it’s core to what we do, not an upsell. When a door won’t close at night or won’t open in the morning, that’s a same-day safety and security problem, and we treat it that way. If you’re facing a door that won’t secure your home or a car stuck inside the garage, call (866) 937-7597 and we’ll get you booked. We’re closed on Saturdays, but a door that fails on a Saturday can be booked for Sunday.
We don’t pad the price for a panic call. The cost of the repair is the cost of the repair. What matters is getting a trained eye on the door before someone tries to force it open or closed and makes it worse.
Why Choose Federal Way Garage Door Repair Pros for Kent Doors
We’re a residential garage door specialist, not a general handyman service, and that focus shows in how we diagnose. Because we work on LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor equipment, we recognize brand-specific behavior instead of guessing at it. Springs get their own dedicated service because that’s the highest-risk component in the system. And we cover the full arc, from diagnosis and repair to opener-specific repair, spring replacement, and new door installation, so the same people who fix today’s problem can spec a new door down the road.
Our technicians have up to 14 years of experience, and the local professionals we connect you with are licensed and insured as their state requires. If you’re checking pricing as part of a broader look at home upkeep, our main page on Federal Way Garage Door Repair Pros explains how we handle the full range of services.
FAQs – Garage Door Cost in Kent
How much does garage door repair cost in Kent?
Garage door repair in Kent typically costs $150 – $600, depending on what failed. A single worn roller sits near the bottom of that range, while a multi-part repair with cables and track work sits near the top. Call (866) 937-7597 for an exact quote; estimates are free.
How much does a new garage door cost in Kent?
New door installation in Kent typically runs $700 – $2200, driven by door size, material, and how much hardware needs replacing with it. The written estimate sets the final price. Call (866) 937-7597 to get a number for your door.
Is it cheaper to repair or replace a garage door?
Repair is usually cheaper when the door structure is sound and a part simply failed, and that repair lands in the $150 – $600 range. Replacement makes more sense when panels are damaged, the frame is warped, or repairs are piling up toward the cost of a $700 – $2200 install. We’ll give you both figures so you can compare. Call (866) 937-7597 for a free estimate.
How much does spring repair cost in Kent?
Spring repair in Kent typically costs $180 – $340 for one spring. Since matched pairs are almost always replaced together, a pair costs about twice that range. Springs are the most dangerous part of the system, so this is skilled work, not a DIY job. Call (866) 937-7597 for a quote.
Can you come today if my door is stuck?
Emergency garage door service is available, and same-day availability is the goal for a door that won’t open or close. If your door is stuck and your home isn’t secure, call (866) 937-7597 and we’ll book you as soon as we can. A door that fails on a Saturday can be booked for Sunday, since we’re closed on Saturdays.
Get Your Free Kent Garage Door Estimate
Pricing a garage door job shouldn’t be a mystery. We’ll look at your door, tell you what’s wrong in plain terms, and put a written estimate in your hands before anything starts. Estimates are free, and we’ll tell you honestly whether repair or replacement is the better value for your situation. Call (866) 937-7597 to get scheduled.
Pricing reflects the Kent market as of 2026. Federal Way Garage Door Repair Pros offers free estimates – call (866) 937-7597.
What Our Customers Say
"Replaced the bottom panel after I backed into it. Color match is close enough that you have to know to look for it."
- Eric Bennett"Both cables had come off the drum and the door was hanging crooked. I'd watched a video and was about ten minutes from trying it myself, which the tech told me would have been a genuinely bad idea. Glad I called."
- Sarah Parker"Door installed in about four hours, old one hauled away, and he stayed to program both cars and the wall panel before he left."
- Bryce Quinn